Clevo N350TW, Руководство по обслуживанию, Страница: 44 / 112

Disassembly
2 - 20 Removing the Keyboard
2.Disassembly
Removing the Keyboard
Figure 15
Keyboard Removal
a. Remove screws from the
bottom of the computer.
b. Eject the keyboard using
a special eject stick to
push the keyboard out
while releasing the key-
board as shown.
c. Carefully lift the key-
board up and disconnect
the keyboard ribbon ca-
ble from the locking col-
lar socket.
d. Remove the keyboard.
1. Turn off the computer, remove the battery ( page 2 - 5 ), and the component bay cover ( page 2 - 9 ).
2. Remove screws
-
from the bottom of the computer.
3. Open it up with the LCD on a flat surface before pressing at point to release the keyboard module (use an eject
stick to do this) while releasing the keyboard in the direction of the arrow as shown ( Figure 15b ).
4. Carefully raise the keyboard up, being careful not to bend the keyboard ribbon cable .
5. Disconnect the keyboard ribbon cable from the locking collar socket ( Figure 15c ).
6. Carefully lift up the keyboard off the computer ( Figure 15d ).
7. Reverse the process to replace the keyboard (make sure to reconnect the keyboard cable).
1 2
3
4 5
6
6 7
8

Re-Inserting the
Keyboard
When re-inserting the
keyboard firstly align the
five keyboard tabs at the
bottom ( Figure 15d ) at
the bottom of the key-
board with the slots in the
case.
a.
Keyboard Tabs
1
2
b.
c.
8
6
7
5
d.
8
3
3
4

4. Eject Stick
8
Keyboard
• 3 Screws