Clevo N350TW, Руководство по обслуживанию, Страница: 37 / 112

Disassembly
Removing and Installing a Processor 2 - 13
2.Disassembly
Processor Installation Procedure
1. Insert the CPU ( Figure 9a ), pay careful attention to the pin alignment, it will fit only one way (DO NOT FORCE
IT!) ( Figure 9a ).
2. Move the bracket and latch fully in the direction indicated to lock the CPU.
3. Apply the thermal grease to the top of the CPU as shown ( Figure 9b ).
4. Remove the sticker ( Figure 9c ) from the heat sink unit (if it is a new unit).
5. Insert the heat sink unit as indicated in Figure 9c .
6. Tighten the CPU heat sink screws in the order - (the order as indicated on the label and Figure 9d ).
7. Replace the component bay cover and tighten the screws.
A
B C
D
E
F
1 4
b.
B
a.
F
Note :
Tighten the screws in the order as indi-
cated on the label.
A
c.
E
d.
F
1
2
3
4
C
D
Figure 9
Processor
Installation
a. Insert the CPU.
b. Move the latch and
bracket fully in the direc-
tion indicated to lock the
CPU. Apply thermal
grease.
c. Remove the sticker from
the heat sink unit and in-
sert the heat sink.
d. Tighten the screws.

A. CPU
F. Heat Sink
• 4 Screws