Clevo N140WU, Руководство по обслуживанию, Страница: 29 / 96

Disassembly
Removing the Keyboard 2 - 5
2.Disassembly
Removing the Keyboard
1. Turn off the computer, turn it over.
2. Remove screws - from the bottom case ( Figure 1a ).
3. Open it up with the LCD on a flat surface before pressing at point to release the keyboard module (use the spe-
cific eject stick to do this) while releasing the keyboard in the direction of the arrow as shown ( Figure 1b ).
4. Carefully lift the keyboard up, being careful not to bend the keyboard ribbon cable . Disconnect the key-
board ribbon cable from the locking collar socket ( Figure 1c ).
5. Carefully lift up the keyboard off the computer ( Figure 1d ).
6. Reverse the process to install the keyboard (be careful not to bend the keyboard ribbon cable).
1 2
3
4 5
6 7
8
6
b.
c. a.
1
6
7
8
4
2
3
c.
5
6

4. Eject Stick
6. Keyboard
Figure 1
Keyboard Removal
a.
b. Release the keyboard by
pressing at point .
c. Disconnect the keyboard
ribbon cable from the
locking collar socket.
d. Remove the keyboard.
3