NT-100 Peristaltic Pump Filler
Page 13
3.2
Driven Pump And Dispensing Air
3.2.1 Switch the filling mode to the left to Test Mode.
(Marked 4 in the picture on the right.)
3.2.2 Adjust the filling speed over than 70. (Marked 2 in the
picture on the right.)
3.2.3 Aim the opening of the output tube to the tank or
other container and push the start button continuously.
When the pump starts operating, the liquid will be sucked
and filled into the filling tubes.
3.2.4 Please push the start button continuously until there
is no more air in the filling hosess and then assemble the
filling nozzle back to the opening of the outlet hose
immediately.
3.2.5 Fix the filling nozzle onto the bracket
and then the preliminary operation is done.
TIP 01:
While testing, please adjust to HIGH filling speed to
help the air to eliminate from the filling hoses. (This action
can prevent from influencing the filling process afterward.)
TIP 02:
The liquid in the hoses has to flow out smoothly
without air so that it will not affect the filling accuracy.
TIP 03:
The best way to fill is to let the surface of the filling
liquid in the tank higher than the pump.