How do I install and remove my Foonf/Fllo
Drink-thingy?
Foonf/Fllo Drink-thingy Installation
Step 1
Select side of seat cup holder will be installed on.
Locate
on the underside of rear-facing belt path (left or right side of seat).
on corresponding cup holder attachment.
Step 2
Move opposite end of cup holder attachment into rear-facing belt path and press firmly to
securely snap into place.
Step 3
Slide the cup holder tab down into the securely mounted cup holder attachment.
NOTE:
When the car seat is installed rear-facing with a vehicle belt, the cup holder can ONLY be
used on the side closest to the seat belt buckle.
Foonf/Fllo Drink-thingy Removal
Step 1
Remove seat
cushion. See “Removing / Installing Seat Cushion” in your car seat manual.
Step 2
Press bottom of cup holder tab and pull up to remove cup holder from attachment.
Step 3
Press and hold
While holding inner tab, use other hand from inside the seat to push cup holder attachment out
of rear-facing belt path.
•
It may be necessary to lift the bottom edge of the car seat cover to push the cup holder
attachment out.
Step 4
Remove cup holder attachment from car seat by sliding outer tab from slot on the underside of
the rear-facing belt path.
Can I use the Drink-thingy for Foonf and Fllo
with any brand of car seat?
The Drink-thingy for Foonf and Fllo is designed, tested, and approved
ONLY
for exclusive use
with Clek car convertible seats.
