Cleco mPro400GCD-P, Описание аппаратуры, Страница: 10 / 48

10 P2300HW | 2019-03 Apex Tool Group
1
EN
5 Pin assignment
This chapter describes the Cleco Production Tools specific
connectors. Standard plugs are not considered. All con-
nections are short-circuit proof.
X5, X6 – Serial port for additional devices
• All outputs provide RS232 conforming signals.
• The inputs allow voltages in the range from -15 V to
+15 V.
-
Voltages < 0.8 V correspond to a zero.
- Voltages > 2.4 V are interpreted as a one.
- Open inputs are preset to zero using a pulldown
resistor.
• The power supply pins are connected directly to the
main board power supply
.
X7, X8 – Anybus CC
Optional slots for Anybus CC modules.
X21 – TSnet System Bus Out
Interface port for TSnet cable.
X22 – ARCNET system bus
The station controller has an integrated bus termination;
therefore, no external termination is necessary.
X23 – Supply
X24 – Tool Cable 30/50E×N… Series
X25 – Tool cable 18/48E×E… Series
Note
Do not connect or disconnect any device
during operation. Doing so may result in a
system reset.
Pin RS232-1
X5
RS23-2
X6
9 pin D-Sub male
with screw lock
1 – –
2 RxD RxD
3 TxD TxD
4 – –
5 GND GND
6 – –
7 RTS RTS
8 CTS CTS
9 – –
Pin Signal 8 pin M12 circular connector
X-coded
1 Tx +
2 Tx -
3 Rx +
4 RX -
5 0 VDC
6 0 VDC
7 +24 VDC
8 +24 VDC
2
1
8
7
6
5
4
3
Pin Signal 8 pin M12 circular connector
A-coded
1 N.C.
2 DATA-B
3 GND
4 +5 VDC
5 DATA-A
6 N.C.
7 0 VDC
8 +24 VDC
Description IEC connector C14
Connector with fuse holder
2-pin, 5 × 20 mm, 16 A slow-
blow
Note
Use plug locking mechanism. See P2361-
JH.
Pin Signal M23 circular connector
1-3 Power
4 PE (functional
ground)
5 Tool bus
Pin Signal ECTA circular connector
Push-pull
1-3 Power
4 PE
5 Signals
Output (Sockel)
6
7
8
2
3
4
5
1
1
2
3
4
5
5
1
2
3
4