6
P2332BA | 2019-08
Apex Tool Group
2
EN
2
Safety
Basic requirements
•
Only operate the socket tray after you have read and
fully understood this document. Failure to follow the
directions and safety instructions could result in elec-
tric shocks, burns and/or injuries.
•
Keep this document in a safe place for future use!
Make this documentation available to the designer, the
installer and the personnel responsible for commis-
sioning the machine or system in which this product is
employed.
Intended use
The product is a part of the Cleco Production Tools tighten-
ing system and is intended exclusively for industrial use in
fastening processes. Use the socket tray under the follow-
ing conditions:
•
Only use the socket tray in conjunction with a
Cleco Production Tools Primary or Master controller.
•
Use a separate socket tray for each tool.
•
Only under the specified ambient conditions.
•
Only with the permissible supply voltage.
•
Only in areas of EMC Limit Class A (electromagnetic
immunity for industrial areas). For the currently
observed EMC standards, see the EC Declaration of
Conformity.
•
Remove the battery to store the socket tray.
Operator training
The socket tray may only be commissioned, adjusted and
tested by qualified and trained personnel. The personnel
must be instructed by qualified employees
1
of
Apex Tool Group. The inserts for the socket tray sockets
may only be changed by qualified employees
1)
. The socket
tray may only be adjusted to special requirements by quali-
fied employees
1)
.
Foreseeable incorrect usage
Do not use the socket tray:
•
in potentially explosive areas
•
in damp spaces/outdoors
•
as a hammer/impact tool
•
with outside control or battery
•
Only use Apex Tool Group battery charger 24 V
(935391) for charging.
Power supply
Operation with 26 V battery pack (935377), a 44 V battery
pack (936400PT) or a PM 48 power module (961350PT).
Operation
Only use the socket tray when it is closed. Operation with
the device open causes the following:
•
An increased amount of emissions: this can cause
interference with other devices.
•
Reduced immunity from interference: the socket tray
can produce faulty results.
•
The loss of existing warranty entitlement.
Warnings and notices
Warning notices are identified by a signal word and a picto-
gram:
•
The signal word describes the severity and the proba-
bility of the impending danger.
•
The pictogram describes the type of danger
Structure Of Warnings
Symbols on the product
Make sure that the meaning of the symbols has been
understood before using the socket tray.
1.Due to their professional training, knowledge,
experience and understanding of the circumstances
involved in this kind of work, suitably qualified
employees are able to identify potential hazards and
to initiate appropriate safety measures. Qualified
personnel must comply with regulations.
Note
A symbol combined with the word
Note
in-
dicates a potentially
harmful situation
which, if not avoided, could result in dam-
age to property or the environment
.
General instructions
include application
tips and useful information, but no warn-
ings against hazards.
Note
Type and source of danger.
Possible consequences of non-obser-
vance.
Measures to avoid danger.
CE compliant
The product corresponds to the prescribed
technical requirements in Europe.
Read all instructions.
Observe generally valid disposal guide-
lines such as, in Germany, the Electrical
and Electronic Equipment Act (ElektroG)
and the Battery Act (BattG).