16
P2332BA | 2019-08
Apex Tool Group
7
EN
7.3 Main menu
Warning message
If there is no more activity on the socket tray, a countdown
appears on the display. This indicates the remaining time
until the socket tray shut off. If new activities are carried out
on the socket tray during this time, the countdown is inter-
rupted and starts again from the beginning.
However, if the warning message
Batt. low
is displayed,
the countdown until power is switched off is no longer inter-
rupted.
Both warning messages can be set via the control software
used.
7.4 Submenu
To change from the main menu to the diagnosis menu,
press the On-/Off button or the function key <F2> and hold
it for two seconds. To exit the diagnosis menu and return to
a higher menu level, press the function key <F1> and hold
it for two seconds.
To select menu items, press the <on/off button>. There are
different submenus.
7.4.1 Administration submenu
7.4.2 Diagnostics submenu
Diagnostics
Diagnostic functions for the socket tray.
Administration
Displays general points such as serial
number, software version ….
LMC
Shows the
LiveWire Memory Chip
set-
tings.
Wireless transmission
Shows settings of wireless transmission
.
Warning time befor shut off
Displays the countdown before shut off.
Battery low
Displays a warning message when the
battery voltage falls below a defined
limit.
In this case, recharge battery or replace
it with one that is already charged.
>Main
Diagnos-
tics
>Main
Adminis-
tration
>Main
LMC
>Main
Wireless
WLAN
Power
down
mm:ss
Batt.
low
Serial number
Display of serial number.
Controller software version
Displays the installed software version.
Hardware configuration
Number of programmed initiators and
status LEDs.
Voltages
Second line: Current battery voltage. If
the voltage drops below limit, a warning
is output on the socket tray.
Third line: Programmed value.
LED test
The functional readiness of the status
LEDs can be visually checked with the
LED test. All status LEDs light up briefly
in different colors.
To activate the function, press the
On/Off button.
S/N
000000
245
Vers.
V1.00.
00
HWkonf
Ini 08
LED 08
Voltage
V26.40
U19.00
Lamp
test