24
P2291BA | 2020-05
Apex Tool Group
9
EN
9.3.3 Main menu
9.3.4 Administration submenu
9.3.5 Diagnostics submenu
Shows general items such as Date/
Time, Counter display, etc.
Diagnostic functions for the tool.
Optional –
Position
– Selects the position to be
used next.
Optional –
Deletes a previously read barcode and
activates a new read cycle.
Shows Settings
LiveWire Memory Chip
.
Shows settings of wireless transmission
.
Date / Time
Displays the tool system time.
The system time can be displayed in US
or European format.
Refer to "Setting the system time on the
control" under
Administration > Date >
Time
.
Set the system time, refer to Con-
trol.
Counter status
The tool counter display is incremented
after each rundown throughout the ser-
vice life of the tool.
Refer to control under
Diagnostics >
Tool > Tool Memory.
Optional -
Active when service counter was acti-
vated by Apex Tool Group.
Number of rundowns under load.
>Main
Admini
strati
>Main
Diag-
nostic
>Main
Posi-
tion
>Main
Scan-
ner
>Main
LMC
>Main
RF
WLAN
Time
07:47
30.09
Counte
99
XXXXXX
Counte
load
XXXXXX
Optional -
Active when service counter was acti-
vated by Apex Tool Group.
Number of rundowns until next service.
Serial number
Serial no. display.
Control software version
Displays the installed software version.
Servo software version
Displays the installed software version.
Activating add-on parts fitted on platform
(scanner, TAG…).
TQ calibration
This test function cyclically recalibrates
the system with the values used immedi-
ately before the start of a rundown. For
this, the tool must not be tensioned!
First line: Calibration test and status.
Second line: TQ calibration voltage.
Third line: Offset voltage. If a value lies
outside the tolerance range, the corre-
sponding error is displayed.
Counte
serv
XXXXXX
S/N
000000
245
Vers.
V1.00.
00
Servo
V:T10C
N00015
Platf
None
Cal OK
K 1.11
O 0.00
Valid until transducer
serial number 168696:
Valid from transducer
serial number 168696:
Value
Rated
value
Tolerance
TQ calibration
voltage
1,10 V
± 45 mV
Calibration
offset
0 V
± 58 mV
Value
Rated
value
Tolerance
TQ calibration
voltage
1,21 V
± 0,05 V
Calibration
offset
0 V
± 0,05 V
