Apex Tool Group
P2544PM | 2021-02
25
3
EN
3.7.4
Setting the shut-off properties
This menu is only available in the FastApps mode. In the mPro mode, the values can only be changed via
the controller.
>
Fig. 3-16: Submenu – Setting the shut-off properties
3.7.5
Selecting the torque units
The torque values on the run screen are displayed in the selected units. The selection is also used for the
data export.
Fig. 3-17: Submenu – Selecting units
Button
Description
Shutoff after idle mode.
Enter the time in minutes after which the tool switches off if no button or key has been
pressed.
Undervoltage limit
Enter the voltage in volts for the undervoltage limit.
The undervoltage limit indicates when a battery change is necessary. If the battery
voltage falls below the defined value, a gray battery symbol flashes on the LCD.
13.50
15
Nm
