Apex Tool Group
P2544PM | 2021-02
15
3
EN
3.4.4
Tool locked
If a warning occurs, one of the following messages appears in the run screen:
Symbol
Description
Warning that the battery has reached the undervoltage limit. The symbol is displayed
until the rundown is completed. Then the tool is locked.
If WLAN is used, the IP address is assigned twice.
Change the IP address.
If Bluetooth is used, the node number is assigned twice.
Change the node number.
The tool is locked because the time, which the tool is allowed to work in offline mode,
has expired.
Reconnect the control and the tool.
The tool is locked until a new workpiece ID or barcode is scanned.
Scan barcode.
The tool is locked because there is no job for the next rundown.
Select application/batch.
The tool is locked because the battery has reached the undervoltage limit.
Change the battery.
The tool is locked because no tightening parameters are available.
Parameterize parameters in the application/batch.
The tool is locked because the maximum number of NIO results has been exceeded,
see P2280PM (Reject Release).
Use counterclockwise rotation or set Reject Release input.
The tool is locked by the controller.
Check the error message in the run screen on the controller.
?
