Apex Tool Group
P2544PM | 2021-02
13
3
EN
3.4
Run screen
The run screen displays the rundown data for the tightening sequence. The structure of the run screen is
equal in mPro and FastApps mode.
Fig. 3-3: Run screen with a rundown result of the FastApp 3
Symbol
Description
Display of the currently selected FastApp.
Up to ten FastApps can be programmed. The number on the button indicates which
FastApp is selected.
Display of the currently selected Application or Linking group (mPro).
Up to 99 Applications/Linking groups can be programmed. The number on the icon
indicates which Linking group is selected.
Number of tightening positions for a application/batche.
•
If there is only one FastApp, then each result is evaluated.
•
If there is more than one FastApp, the overall result of all the tightening positions
is considered.
Example: 2/3
•
Current tightening position: 2
Total number of tightening positions: 3
Number of repeats when a rework is performed due to NOK rundown. This function is
only available in mPro mode.
The symbol that appears shows the available WLAN or Bluetooth connection.
If the symbols are grayed out, no WLAN/Bluetooth connection could be established
yet.
Display of the torque for the current tightening.
If an arrow pointing up appears next to the symbol, the result is too high.
If an arrow pointing down appears next to the symbol, the result is too low.
Display of the angle for the current tightening.
If an arrow pointing up appears next to the symbol, the result is too high.
If an arrow pointing down appears next to the symbol, the result is too low.
Display of the rundown status.
Error messages for shut-off cause, page 47.
1
03/03
45,3
Nm
620°
OK
1
1
OK
