Menus and Functions
40
P2398PM | 2018-12
Apex Tool Group GmbH
3
EN
To change the tool constant:
1. Select
to activate the input box.
2. Increase/decrease the value of the tool constant with the
and
or
and
buttons.
3. To confirm the change, press
.
→ The checkmark is highlighted in green.
→ The tool constant is saved.
→ The
Tool constant
menu is exited.
To not save a tool constant change, exit the menu with the
button.
3.10
Communications
In this menu, information about the WLAN connection is to be found. To configure WLAN settings, use the
LiveWire RF Configuration
software. See Document
P2372JH
.
If the tool is programmed so that WLAN settings are assigned via DHCP, this will appear to the right near
the "-" symbol as long as no connection could be established.
>
Abb. 3-31: Menu – Communications
Button
Description
Display of the tool constant.
The tool constant can be changed by
± 20%.
To prevent unintentional changes to the tool constant, every change must be con-
firmed.
Press to confirm a tool constant change.
Symbol
Description
SSID display.
IP address display.
Network mask display.
IP
NM
192.168.245.1
255.255.255.0
mPro_a84484
IP
NM
