Cleco 35PTHH, Инструкция по эксплуатации

Страница: 9 / 42

2123b_1_5_en_ bedingt.fm, 03.07.2014
P2122BA/EN 2014-06 9
Before initial operation
4
3.2 Options
4 Before initial operation
4.1 Air supply
 Make sure that the pressure before the pressure regulator is at least 0.5 bar higher than the required
inlet air pressure at the tool.
 Keep the inside of the air hose free of residue; clean it if necessary.
Air quality
In accordance with ISO 8573-1, quality class 2.4.3, compressed air must be dry and clean.
Air preparation units
Our recommendation: air preparation units (filters, regulators, lubricators) should be installed
5 Connection for evaluation electronics TVP100
6 Start button
7 Reserve oil adjustment, see 6.2 Fill reserve oil, page 16
8 Suspension bail
9 Hex wrench (WAF 2), order no. 935490
Order no. 934918
Signal connection kit
for evaluation elec-
tronics TVP100 Protective sleeve
Order No. 937448PT – 35PTHH…
Order No. 937443PT – 35PTHHA…
Vibration absorber
Order No. 935965 – 35PTHHA…
Parameter Data
Air hose Inner diameter 3/8" (ø 9.5 mm), maximum length 5 m
Air inlet 1/4" NPT, inner diameter

7.5 mm
Parameter Data
Working pressure range 400 … 700 kPa
Max. dew point + 10° C
Device Explanation
Filter Retention of particles > 15 micrometers.
Removes more than 90% of condensation.
Item . Designation