Step 3:
Assemble the notched ends of the pipe to the 3-way couplers. The notched pipe has
pre-drilled screw holes. Couplings have no holes.
Step 4:
Install the supplied hex driver bit into the chuck of your drill/driver.
Step 5:
Fasten the rafter sections to the coupling using 3/4" Tek screws. Go through the guide holes
in the rafter pipes into the coupling.
Tip:
Tek screws are self-drilling and no pilot hole is usually required. If you have trouble
getting a Tek screw to “bite,” try another Tek screw (or you can drill a 3/16" pilot hole).
Page 8
