41
CLEARSPAN
™
MAJESTIC GREENHOUSES
Revision date: 06.21.16
Complete the following general steps to install the end wall
panels.
1. Consult the panel location diagrams, select one 6" x 8"
polycarbonate panel, begin at the edge of the opening
for the double door, and work to the outside edge of the
end wall.
See the X in the diagram below for the first panel.
NOTE:
Remove the protective film. When needed, an
upper panel is cut to length
after
attaching it to the end
wall frame and rafter.
Always remove the protective film and mark and install
the UV-protected side to the outside of the greenhouse.
2. Apply white vent tape to the bottom and top edge of the
lower panel and then install the aluminum U-channel
profile (104213)
to the edge of the panel adjacent to the
door
as shown on the Polycarbonate Panels diagram
near the back of these instructions.
END PANEL INSTALLATION (continued)
NOTE:
When attaching any profile, remember to
account for the areas where different sections of profile
intersect so that the profile is cut to the proper length.
Space the screws evenly at 24" when securing the
panels.
Do not use washers when securing the
H-channel to the end wall framing.
DO NOT install profile on the bottom or top edge of
the lower end panels.
These edges are sealed with
the white vent tape only.
The upper edge of all lower
panels is overlapped by the end cap profile attached
to the lower edge of the upper panels when these are
installed.
Cut upper end panels flush with the edge of the
installed roof panels. For best results, end panels
should lap under the edge of the installed roof panels.
Tape or seal with silicone the upper edge of the upper
panels before securing them to the frame.
In this photo, the excess upper end panel is removed
using a power tool equipped with a round cutting bit. A
utility knife can also be used.
Exercise caution!
3. Place the panel in position and attach it to the end wall
framing using neo-bonded washers and the long Tek
screws (FA4484B).
The greenhouse in this photo is used for illustration
only. Actual model may differ. Roof panels and hat
channel runs are not shown.
Mark UV Side
X
Apply vent tape to
lower edge.
Cut upper panel
to proper length.
Panel installed later
in these instructions.
Dashed line and small arrows (above) show where to
install the white vent tape.
Install vent tape along the
bottom and top edges of the lower panels.
X
4 x 8 4 x 8
6 x 8
6 x 8
6 x 8
6 x 8
6 x 8
6 x 8
Panel installed
later in these
instructions.
Panel installed
later in these
instructions.
Door is installed later
in these instructions.
End panel located
above door opening.
104213
End Panel
