Clear-Com FreeSpeak Edge Transceiver Скачать руководство пользователя страница 1

Page 1        399G327 Rev A   08 April, 2020 

 

 

  

 

 

 

 

 

 

 

 

FreeSpeak Edge™ is a member of Clear

-

Com’s FreeSpeak™ family of digital wireless intercom solutions.

 A 

FreeSpeak Edge IP transceiver forms a link between FS Edge 5GHz beltpacks and a Clear-Com matrix (E-
IPA-HX interface card). The transceiver is designed for use on AES67 enabled Local Area networks (LAN). It 
requires careful setup of an AES67 compatible network switch with PTP. For details see: 

Clear-Com AoIP 

network and switch recommendations

Powering options: FS Edge transceiver 

 

Power over Ethernet (PoE). Connect to LAN1 (RJ45)

*

 

 

Local power. Use the power supply unit provided with the transceiver 

 

USB battery pack (transceiver standalone mode only). Requires USB C connection with 3A, 5V 
output. 

*

The transceiver is a Class 3 PoE device. If you exceed the power budget of your switch the units will 

malfunction.  

Reset transceiver to default 

1.

 

Press and hold the mode button for 12 
seconds. When the status LEDs turn red, 
release the mode button.  

 

This will reset the transceiver to DHCP mode and 
remove any stored diagnostics. 

The Admin and audio (AES67) IP addresses are 
reset to DHCP, RF output power will reset to 18 
dBm and radio channels will default to 132 and 140.  

Reset can take up to 5 minutes

.  

Transceiver standalone mode 

Use standalone mode to connect two beltpacks (full 
duplex audio) for performing an initial site survey or 
demo. To enable standalone mode: 

1.

 

Press and hold the mode button while 
simultaneously powering the Edge 
transceiver. When the status LEDs turn 
yellow, release the mode button. The 
transceiver will then work through its 
startup sequence. When the device is ready, 
LED 1 is steady and LED 2 flashes yellow. 

 

Transceiver has entered 
standalone. Release the mode 
button. 

The transceiver can take up to 
5 minutes to boot in 
standalone mode.

 

 

LED 2 flashes yellow. The 
transceiver is ready for beltpack 
connection. 

 

 

 

 

Quick  

Start 

Guide 

FreeSpeak 

Edge™ 

Transceiver 

Отзывы: