background image

 

 

                 

Quick Start Guide

 

 
This quick start guide describes how to set up a basic 

Eclipse HX™ digital matrix system

. It 

explains how to: 

 

Connect Eclipse HX interface cards, user panels and other devices to the matrices. 

 

Check that your connected hardware devices are functioning correctly (without having to 
configure the matrices). 

 

Set up the EHX configuration software on the PC. 

 

Set up and configure the matrix. 

 

Tip:  

For detailed help with setting up and configuring your Eclipse HX system, see the full Eclipse 

HX documentation set on the Eclipse HX DVD(s)

.  

1.1  Connecting your Eclipse HX devices  

To connect your Eclipse HX devices to the matrix: 

1.  Ensure that the Eclipse HX matrix is unpowered. 

2.  Check that all the required interface cards (MVX-A16, E-QUE, E-MADI64, IVC-32, LMC-64 

and E-FIB front and rear cards) and interface modules (in the case of the Eclipse HX-
Median and Eclipse HX-Delta) have been inserted into the matrix.  

3.  Connect the rear cards to the user panels, then the interfaces, leaving unused ports until 

last. 

4.  Connect the matrix to your network (see next section). 

5.  Power up the Eclipse HX matrix. 

1.2  Connecting the EHX PC  

The Eclipse HX matrix is set up to automatically obtain an IP address from a DHCP server on your 
network. If no DHCP server can be located, the matrix defaults to the IP address of 

169.254.0.100

.  This enables the PC that will host your EHX configuration software to 

automatically acquire an IP address to communicate with the matrix through a directly connected 
Ethernet cable.  
 

Note: 

if you are using an older PC you may require an Ethernet crossover cable. If the Ethernet port 
status and activity LEDs are not lit when the PC and matrix are powered and the cable is 
connected, the cable is probably of the incorrect type.  

Eclipse HX Quick Start Guide  
PN: 399G065 Rev: A  08/22/13 

 

Отзывы: