Clear-Com Eclipse Median, Инструкция по эксплуатации

Страница: 72 / 114

Vitec Group Communications
Eclipse Median Instruction Manual
5 - 4
INSTALLING THE ECLIPSE MEDIAN MATRIX
The following overview gives you a summary of the steps required to
install an Eclipse Median matrix. More detailed information on each
step is provided in the sections that follow.
To install an Eclipse Median matrix
1. Remove the Eclipse Median chassis from its shipping carton.
2. Leave at least 2 inches (51 mm) of clearance on all sides of the
matrix chassis to ensure proper airflow. Do not block ventilation
vents.
3. Check the position of circuit cards, power supplies, and
rear-connector panels. Later sections in this chapter give more
information on these items.
4. Apply AC power to the unit. The unit has two separate AC power
entry connectors for the two separate power supplies in the system.
INSTALLING POWER SUPPLIES
The Eclipse Median system’s DC power supplies run on AC mains
power. Two identical Euro Cassette power supplies are provided to
ensure that every matrix will have redundant power—that is, to ensure
that the matrix will continue to operate even if one supply output fails.
Each of the power supplies must be connected to a dedicated branch
of AC mains power. The matrix will continue to operate even if one of
the AC power branches fails.
Clear-Com ships each matrix with power supplies already installed.
When you receive the matrix, connect the power supplies to AC mains
power using the IEC power connectors on the matrix’s rear panel.
A fully equipped Eclipse Median (5 port cards, 2 expansion cards, and
8 interface modules) requires 100 to 240 VAC at 40 to 50 Hz with a
maximum dissipation of 400 W.
INSTALLING THE REAR RJ-45 CONNECTOR
PANELS
The matrix’s rear panel is constructed of modular,
individually-installable connector panels. Each front interface card has
a corresponding rear-connector panel; for example each MVX rear
connector panel holds 16 RJ-45 connectors.
Clear-Com ships each matrix with the required number of
rear-connector panels already installed. Blank rear panels fill unused
card slots.