Clear-Com Eclipse HX series, Руководство пользователя

Страница: 77 / 230

Eclipse | Upgrade Guide
Page 77
6 Upgrading the Eclipse HX-PiCo
This chapter describes how to upgrade the Eclipse HX-PiCo matrix, including the PROM,
FPGA and application code.
The Eclipse HX-PiCo PROM is different from the PROM used with the CPU cards, which
are fitted to the Eclipse HX-Median, Eclipse HX-Omega and Eclipse HX-Delta matrices.
Care should be taken to ensure that the correct PROM is fitted.
Note: If you are upgrading your PiCo to an HX-PiCo please contact your Clear-Com
representative to establish if your hardware is HX ready. If your PiCo hardware is not HX
ready then this is a factory only upgrade.
Note: This guide is laid out in the order in which you must upgrade your Eclipse HX software
and hardware devices. For a quick reference to upgrading your system, see
3Quick reference: Upgrading to Eclipse HX .
Note: The HX-PiCo mainboard needs a factory hardware modification.
Eclipse HX devices are powered by mains voltage . Unless
specifically advised to the contrary, disconnect mains supply before
carrying out any maintenance or repair tasks. Observe precautions
for handling electrostatic sensitive devices.
6.1 Changing the Eclipse HX-PiCo PROM
Note: When you change the Eclipse HX-PiCo PROM, you must also change the Eclipse HX-PiCo
RAM (from 128Mb RAM to 256Mb RAM). See
6.2 Changing the Eclipse HX-PiCo RAM
below.
To upgrade the Eclipse HX-PiCo PROM:
1) Ensure that you have the following equipment:
Required equipment Description / comments
2MBit PROM device (ST
M27W201 or equivalent).
-
PROM Programming Unit You will also require the appropriate
programming software for the unit.
The appropriate S record
file for the Eclipse HX-PiCo
boot PROM. You can find the S record file on the Drivers
USB:
Drivers USB > ECLIPSE DRIVERS > PiCo-
HX_PiCo_E-32 > xxxxxx
– Boot PROM
(where xxxxxx represents the part number).
Table 6-1: Required equipment
2) Ensure that the Eclipse HX-PiCo is powered off. Remove the lid of the device.