Clear-Com CELLCOM 10, Инструкция по эксплуатации

Страница: 70 / 168

Vitec Group Communications
CellCom-10 Instruction Manual
5 - 1 4
on each antenna that are occupied by beltpacks. This information may
be useful during a site survey, or when troubleshooting coverage areas
or antenna connections.
A typical display is shown below:
Figure 5-22: ANTNS menu
The numbers 1 through 10 represent the maximum number of
antennas that can be connected to the base station. Numbers 1
through 5 can be positions on a splitter connected to transceiver port 1,
while 6 through 10 can be positions on a splitter connected to
transceiver port 2. An antenna connected directly to transceiver port 2
would appear at position 6.
“__” indicates an empty slot on an acive antenna that is connected to
the base station. A number in place of a “__” indicates that this slot is
occupied by the indicated beltpack.
Blank spaces next to an antenna number indicate that no antenna has
been detected in this position.
So, for example, the above display would indicate that five antennas
are connected to the base station in positions 1, 2, 3, 6, and 7. There
are no active antennas in positions 4, 5, 8, 9, and 10.
There are 4 beltpacks currently connected. Beltpacks 2 and 4 occupy
the first 2 slots of antenna 3; beltpack 1 occupies the first slot of
antenna 6; and beltpack 3 occupies the first slot of antenna 7.
The display updates every 4 seconds to reflect changes in antenna
status and beltpack connections.
Rotate or push in the setup/enter knob to exit this menu.
SETTING THE IP ADRRESS (“IP”)
When IP is selected a screen appears allowing the IP address of the
base station to be set.
ANTNS MENU
1/ __ __ __ __ __
2/ __ __ __ __ __
3/ 2 4 __ __ __
4/
5/
BACK
6/ 1 __ __ __ __
7/ 3 __ __ __ __
8/
9/
10/
Enter IP address for system 1
167
BACK
161 136 129