Clear-Com CELLCOM 10, Инструкция по эксплуатации

Страница: 67 / 168

Vitec Group Communications
CellCom-10 Instruction Manual 5 - 1 1
Figure 5-17: Key Type Menu
The display automatically returns to the screen for selecting the next
key to program.
7. Select the next key and follow steps 4 through 6. Continue until
sources and destinations have been assigned to all desired keys on
that beltpack.
To assign keys for another beltpack continue selecting the BACK
command on each successive screen until reaching the AVAILABLE
BELTPACKS menu. Highlight and select the next beltpack, and repeat
the above procedures.
SETTING INPUT AND OUTPUT AUDIO LEV-
ELS
The settings at the base station determine the input and output audio
levels of a device connected to a port. The user can adjust the levels
from -20 to +18 dB.
• Setting the “input” level alters how loudly others will hear it.
• Setting the “output” level alters how loudly the user will hear other
audio sources.
To set the audio level for a port
1. From the MAIN menu, select PORTS.
2. Select the port for which the audio levels are to be adjusted from the
AVAILABLE AUDIO PORTS menu.
The SELECTED PORT menu appears.
3. Select LEVELS from the next menu.
The EDITING LEVELS menu appears.
4. Select either Input level or Output level.
5. Rotate the setup/enter knob clockwise or counterclockwise to
increase or decrease the level in 1 dB increments.
6. When the desired audio level appears on the screen, press and
release the setup/enter knob to select it,
7. The changes are saved and applied automatically five seconds after
the last time the setup/enter knob was pressed or turned. The
front-panel display flashes to indicate that the changes are being
saved and appied.
SELECT TYPE OF KEY 2 FOR Bpk02 - BPK02
T+L DTL FL TFL
TLK
LIS