Clear-Com CELLCOM 10, Инструкция по эксплуатации

Страница: 145 / 168

Vitec Group Communications
CellCom-10 Instruction Manual 1 1 - 5
BELTPACK REGISTRATION
Registration is the process of telling the beltpacks which base station
to communicate with, and telling the base station which beltpacks to
communicate with.
In some cases the beltpacks shipped with the base station may
already be registered to it, in which case there is no need to use this
tool immediately. However the user will need to use it if they are not
registered, or if new beltpacks are shipped to replace faulty or
damaged ones, or if there are a number of base stations and it is
required to switch beltpacks between them.
The registration process involves two steps: firstly entering the
beltpack serial numbers into the base station, and secondly
programming the beltpacks with the base station system ID.
ENTERING BELTPACK SERIAL NUMBERS INTO THE
BASE STATION
• From the base station front panel, select “BELTPACKS”, and then
the “slot” of the beltpack that the new unit is to be put in, e.g.
BPK01.
• Select RGSTR. The user should now see a menu titled “Enter
beltpack S/N for…” with 4 digits underneath.
• Each beltpack should have a sticker on its rear indicating its serial
number. (If this sticker is missing or damaged, this serial number
can be read using the PC app – see later). Dial the last 4 digits of
this serial number into the base unit, then select BACK, then
BACK again to return to the list of beltpack slots.
• Repeat the process for all the beltpacks that are to be registered.
• Apply the changes by either holding down the rotary controller for
5 seconds (this must be done after selecting BACK from the
Register menu) or by selecting “SYSTEM>SAVE” from the main
base station menu.
To de-register a beltpack, from the base station front panel, select
BELTPACKS, then the slot where the beltpack is currently registered,
then RGSTR, and enter “0 0 0 0” as the serial number.
ENTERING THE BASE STATION SYSTEM ID INTO
THE BELTPACK
• Connect the beltpack to the PC using the beltpack serial cable (9
way female DIN to 3.5mm stereo jack). If one of these cables was
not shipped with the Cellcom unit, the pinout is described in the
Figure 11-2. Power up the beltpack.