CleanStar Stellar Vstellar, Инструкция по эксплуатации

Страница: 6 / 10

6
UNPACKING & ASSEMBLY
Check that all the parts are in the box. Refer to breakdown on page 4.
1. Fit the electrical brush by carefully inserting it into the vacuum compartment.
2. Make sure you insert the tube to the correct position into the hand vacuum handle.
3. Fit the crevice nozzle and small brush by inserting them into accessory holder.
CHARGING
Insert the charger into the mains power supply (Note: The hand vacuum should be held in the body).
Always make sure that the stick vacuum is turned off, and then connect the charger to the charge hole located
on the side of the stick vac. The indicator light will come on once the stick vacuum starts charging.
The first time charging the stick vacuum, leave on charge for approximately 3 hours to fully charge the
batteries before the first use. In order to ensure that it is always ready for use, the stick vacuum should be left
on connection with the adaptor when not being used until the battery is fully charged. The adaptor may
become warm during charging, this is normal. Once the battery is fully charged, remember to remove the unit
from the charger, as not doing so may reduce battery life and run time.