4
OPERATING INSTRUCTIONS
1. DUST BAG INSTALLATION
a) Open the triangular shaped dust bag cover by gently pressing one end of the locking bar to release the
locking mechanism.
b) Grasp the cover in your hand, lifting the upper corners of the cover away from the vacuum housing.
c) Slide the bottom edge of the cover away so the hinges on the cover slip out of the housing.
d) Inside the dust bag cavity, a round foam filter helps to protect the motor. Be sure this filter is in place prior
to installation of the dust bag.
e) Not applicable.
f) Gently unfold the new dust bag. The upper corner of the dust bag should be slided in so they do not
interfere with the cardboard plate resting securely on the housing.
g) Ease the dust bag into the cavity, placing the cardboard plate onto the exterior lip of the cavity. Make sure
that the cardboard plate is fitted behind the two small clips on the exterior lip.
NOTE: The triangular shaped cardboard plate must be placed evenly on the exterior lips in order
for the dust bag cover to be properly installed.
h) Replace the dust bag. First grasp the cover in your hand, and insert the lower cover hinges into the
indentations. Be sure the dust bag cardboard plate is resting evenly on the lips of the cavity. Close the
cover and make certain it clicks into place.
