5900e Greensand Filter Installation & Startup Guide
Page 9
www.cleanwaterstore.com
Rev 082216
b)
If the valve you are attaching the bypass to has a flow sensor
(see picture 3
), lube the two O-
rings and push the bypass assembly onto the flow sensor, and attach the steel mounting clips
and screws.
3.
If the valve you are attaching the bypass to does not have a flow sensor, then it has the same
type of barrels that are on the opposite side of the bypass. Take out the barrels and apply
silicone grease to all four O-rings and push in the barrels and attach the bypass.
Assemble The Drain Line Flow Control Hose Barb:
Remove the clip, and then remove the Drain Line Fitting. Apply Teflon tape and paste to the Hose Barb
Fitting. Screw them together. Install the proper Drain Line Flow Control Button.
Remove the clip and the Drain Line Fitting (1
st
pic). Add Teflon tape and paste (2
nd
pic). Install DLFC