Clavister SG4300 Series, Руководство по началу работы, Страница: 46 / 68

3.4. CLI Setup
This chapter describes the setup steps using CLI commands instead of the setup wizard.
The CLI is accessible in two ways:
• Across the local network at default IP address 192.168.1.1 using an SSH (Secure Shell) client.
The network connection setup is the same as that described in Section 3.2, “Web Interface and
Wizard Setup” as is the way the workstation interface's static IP address must be set up so it is
on the same network as the Clavister Security Gateway's interface.
If there is a problem with workstation connection, a help checklist can be found in Section 3.5,
“Troubleshooting Setup”.
• Using a terminal or computer running a console emulator connected directly to the local RS-232
console port on the Clavister Security Gateway. Performing console port connection is described
in the hardware installation manual for each Clavister hardware model.
The CLI commands listed below are grouped so that they mirror the options available in the setup
wizard.
Confirming the Connection
Once connection is made to the CLI, pressing the Enter key will cause CorePlus to respond. The
response will be a normal CLI prompt if connecting locally through the RS-232 console port and a
username/password combination will not be required (a password for this console can be set later).
Device:/>
If connecting remotely through an SSH (Secure Shell) client, an administration username/password
must first be entered and the initial default values for these are username admin and password
admin. When these are accepted by CorePlus, a normal CLI prompt will appear and CLI commands
can be entered.
Changing the Password
To change the administration username or password, use the set command to change the current CLI
object category (sometimes refered to as the object context) to be the LocalUserDatabase called
AdminUsers.
Device:/> cc LocalUserDatabase AdminUsers
Device:/AdminUsers>
Tip: Using tab completion with the CLI
The tab key can be pressed at any time so that CorePlus gives a list of possible options
in a command.
Now set the username/password, which are case sensitive, to be the new chosen values for the user
called admin. In the example below, we change to the username new_name and password new_pass.
Device:/AdminUsers> set User Admin Name=new_name Password=new_pass
The new username/password combination should be remembered and the password should be
composed in a way which makes it difficult to guess. The next step is to return the CLI to the default
top level of object categories.
3.4. CLI Setup
Chapter 3. CorePlus Configuration
46