Clavister SG4300 Series, Руководство по началу работы, Страница: 20 / 68

Chapter 3. CorePlus Configuration
• Management Workstation Connection, page 20
• Web Interface and Wizard Setup, page 24
• Manual Web Interface Setup, page 31
• CLI Setup, page 46
• Troubleshooting Setup, page 54
• Going Further with CorePlus, page 56
3.1. Management Workstation Connection
CorePlus is Pre-installed on Clavister Hardware
It is assumed you have now unpacked, positioned and powered up the SG4300 Series unit. If not,
you should refer to the earlier chapters in this manual before continuing. CorePlus is already
installed on the SG4300 Series in the factory and will automatically boot up after switching on
power to the hardware.
The Default Management Interface
After first time startup, CorePlus scans the available Ethernet interfaces and makes management
access available on the first interface found and assigns the internal IP address 192.168.1.1 to it.
For the SG4300 Series, this is the ge1 interface.
Alternative CorePlus Setup Methods
Initial CorePlus software configuration can be done in one of the following ways:
• Through a web browser.
A standard web browser running on a standalone computer (also referred to as the management
workstation) can be used to access the CorePlus Web Interface. This provides an intuitive
graphical interface for CorePlus management. When this interface is accessed for the first time,
a setup wizard runs automatically to guide a new user through key setup steps. The wizard can
be closed if the administrator wishes to go directly to the Web Interface to perform setup
manually.
The wizard is recommended for its simplification of initial setup and is described in detail in
Section 3.2, “Web Interface and Wizard Setup”.
• Through a terminal console using CLI commands.
The setup process can alternatively be performed using console CLI commands and this is
described in Section 3.4, “CLI Setup”. The CLI allows step by step control of setup and should
be used by administrators who fully understand both the CLI and setup process.
CLI access can be remote, across a network to a physical interface using a similar connection to
that used with the Web Interface. Alternatively, CLI access can be through a console connected
directly to the local RS-232 port on the SG4300 Series hardware. Direct console connection is
described in Section 2.3, “Console Port Connection”.
20