Clavister Eagle E20, Руководство по началу работы

Страница: 29 / 76

4.2. Web Interface and Wizard Setup
This chapter describes the setup when accessing cOS Core for the first time through a web
browser. The user interface accessed in this way is called the
Web Interface . It assumes that a
physical network connection has been set up from a management computer to the default
management Ethernet interface as described in
Section 4.1, “Management Workstation
Connection” .
Note: Some screenshot images have been clipped
Many of the images in this section are cut from original screenshots to condense the
information presented. However, all relevant details in the images have been preserved.
Important: HTTP access is disabled for cOS Core 11.01 and later
For cOS Core version 11.01 and later, HTTP management access is disabled in the
default configuration and HTTPS must be used. HTTP access can be enabled by the
administrator but this is not recommended.
Connect By Browsing to https://192.168.1.1
Using a web browser, enter the address https://192.168.1.1 into the navigation window as shown
below.
Important: Disable any proxy server and turn off popup blocking
Make sure the web browser doesn't have a proxy server configured.
The wizard runs in a browser popup window. The popup must be allowed for the setup
wizard to run.
If there is no response from cOS Core and the reason is not clear, refer to the help checklist in
Section 4.6, “Setup Troubleshooting ” .
The cOS Core Self-signed Certificate
When responding to an https:// request, by default cOS Core sends a self-signed certificate which
will not be initially recognized so it will be necessary to tell the browser to accept the certificate
for this and future sessions.
Different browsers handle this self-signed certificate in slightly different ways. In Microsoft
Internet Explorer the following error message will be displayed in the browser window.
Chapter 4: cOS Core Configuration
29