© 2022
Order #XXXXX
Locked layer contains
placeholder marks.
When assembled
Steps:
1) Attach Monitor to Kiosk base, using bolts.
2) Connect power cords to Supernova lights.
3) Apply SEG graphic to front frame of Kiosk.
BACK VIEW
FRONT VIEW
Transformer
SEG Graphic Installation
Corner A
Corner D
Corner B
Corner C
It is important to first insert
graphic into each alternate
corner, then to the sides of
the frame. If this is not done,
graphic will not fit into the
frame correctly.
Step 1
Insert corner A. Turn edge of
graphic so silicon welt is
perpendicular to face of
graphic. Insert narrow side
of welt with fabric to outside
into the channel. Repeat for
other side of this corner.
Step 2
Repeat Step 1 for opposite
corner C, then insert corner
B, followed by corner D, to
complete the installation of
the corners.
Graphic Removal
To remove the graphic from
the frame, locate the fabric
pull tab. Gently pull up on
the tab to remove the fabric.
Step 3
Once all corners are inserted,
press one silicon edge into
channel from corners and
work toward the center.
Make sure welt is fully inserted
into channel. Continue until
all sides are done. Smooth
out edges of graphic.
+
-
Power
Female
Transformer
96W / 4 Amp / 24V
+
+
-
-
Lights
Male
Light to Light Attachment
Maximum of 7 lights per chain / 7 lights per Transformer
Light to Transformer Attachment
SEG Graph
ic
Monitor
Lights
Lights
MOD-1711 Monitor Kiosk
REV 9/2022
If you would like to tell us about your experience with your setup instructions please email us at
SETUP INSTRUCTIONS
