© 2019
Step 2 of 2
Order #XXXXX
Completed Assembly
5B
2B
2A
3B
3A
5A
*
*
*
Item
7/8/9
10A
10/11
11A
Description
Assembled Header Frame
Support Leg
Assembled Counter Support
Mounting Plate
Qty.
1/1/1
1
1/1
1
Steps:
1) Connect lights to [5A/5B]. See
Light Connection
detail.
2) Attach assembled header frame [7/8/9] to [5A/5B].
3) Attach fabric graphic to
Velcro
on back of assembled header.
4) Attach counter support [10/11] to [2A].
5) Attach support leg [10A] to counter support [10/11].
6) Attach shelf to extrusion [2A].
7) Attach counter to mounting plate [11A]. See Counter Attachment sheet.
8) Route USB cords from counter. See USB Cord Management sheet.
9) Attach wings to clamps on [2A/2B] and [3A/3B]. See
Clamp Attachment
detail.
10) Attach graphic to [3B]. See
Graphic Attachment
detail.
Keep [
10
] and [
11
] assembled.
Keep [
7
] [
8
] and [
9
] assembled.
10A
11
10
Graphic
Wing
Wing
Wing
Shelf
*
Slide light onto clip then lock clip
into groove of horizontal extrusion.
Clip
Light
Light Connection
Clip
Light
Horizontal Extrusion
Velcro on extrusions
must face to
BACK
of
assembled Backwall.
*
Connector
Graphic Attachment
Cap
Graphic
Standoff
Slide connector into groove of extrusion.
Tighten set screws to secure in place.
Screw standoff into connector. Place
graphic between standoff and cap then
tighten cap to secure graphic.
When desired location
is found, tighten
set screw to secure.
Slide connector, located on
back of clamp, into groove
of extrusion.
Clamp
Clamp Attachment
Keep clamps attached to verticals, when packing.
Knob
Set Screw
A10 Clamp
11A
VK-1222 Backwall Attachments