w w w . c l a s s i c
e x h i b i t s . c o m
Step 1
Page 1 of 4
866.652.2100
© 2011
WHEN DISASSEMBLING ALUMINUM EXTRUSION, TIGHTEN ALL
SETSCREWS AND LOCKS TO PREVENT LOSS DURING SHIPPING
Order #XXXXX - LTK-1139 - General Layout
Setup:
3) Use standoff screws to secure the front panel with
door and back panel of the pedestal to the side panels.
4) After assembling front, back, and side panels,
slide floor into the bottom of the pedestal. The
floor will sit on pins on the inside of the side panels.
5) After floor is in place, use Velcro attachments to
install shelf.
6) Slide assembled base againt assembled vertical stand,
then secure with thumbscrews, see
NOTE
.
Standoff
Screw
Front Panel
with Door
Floor
Shelf with
Velcro Supports
Item
1
2
3
Description
Base Plate
36”h Lower Vertical Extrusion
36”h Upper Vertical Extrusion
Qty.
1
1
1
Steps:
1) Attach lower vertical extrusion [2] to base plate [1],
See detail D on general info page.
2) Attach upper vertical extrusion [3] to
lower vertical extrusion [2].
1
2
3
QTY. 2
Thumbscrew
attachment
See Note
Modul Vertical Stand
Pedestal Base
M
ONITOR
M
OUNT
A
TTACHMENT
Attach monitor mount to vertical
extrusions after assembly.
Slide Mount into Groove
of Vertical Extrusion.
Tighten
Setscrew
Attach top Plate
and tighten screws
NOTE:
Using door opening go
inside base and attach thumbscrews
to secure pedestal to vertical extrusion.
*
*
