© 2022
Step 2 of 2
Order #XXXXX
Locked layer contains
placeholder marks.
Align hole with pin
Rotate pin. Spring
will push pin into hole.
Counter Top Attachment
1
2
Pin
Hole
SEG Graphic Installation
Corner A
Corner D
Corner B
Corner C
It is important to first insert
graphic into each alternate
corner, then to the sides of
the frame. If this is not done,
graphic will not fit into the
frame correctly.
Step 1
Insert corner A. Turn edge of
graphic so silicon welt is
perpendicular to face of
graphic. Insert narrow side
of welt with fabric to outside
into the channel. Repeat for
other side of this corner.
Step 2
Repeat Step 1 for opposite
corner C, then insert corner
B, followed by corner D, to
complete the installation of
the corners.
Graphic Removal
To remove the graphic from
the frame, locate the fabric
pull tab. Gently pull up on
the tab to remove the fabric.
Step 3
Once all corners are inserted,
press one silicon edge into
channel from corners and
work toward the center.
Make sure welt is fully inserted
into channel. Continue until
all sides are done. Smooth
out edges of graphic.
Completed Assembly
Top View
Back View
Front View
Steps:
1) Wrap
SEG Graphic
around front & sides of counter as shown.
2) Attach Shelf Supports, using
Velcro
then place Internal Shelf on top.
3) Attach Counter Top to assembled base. See
Counter Top Attachment
detail.
Internal Shelf
Counter Top
Shelf Supports
attach with
Velcro
Counter Assembly (cont’d)
