Classe Audio OMEGA - V1.1, Руководство пользователя

Страница: 22 / 30

22
Initial Setup
Your new Classé Omega Mono amplifier is quite simple to set up and
enjoy. Please follow the steps outlined below in order to safely set up
and use your new amplifier.
Important: The AC mains connection should be the last connection
you make on your new power amplifier. In addition, it is
always a good idea to power up your power amplifiers
last, after everything else has been powered up and has
stabilized.
.
Conversely, it is good practice to power the amplifier(s)
down first when shutting down the system, as this
prevents any transients from other components from
getting through to your loudspeakers.
1. Unpack everything according to the included instructions.
Be careful when doing so, as this amplifier is extremely heavy. Two
people in good physical shape are required for this task.
2. Place your amplifier (be sure to read the section Unpacking
and Placement ) and connect it to the AC mains.
This includes deciding on the location, making sure your have ad-
equate ventilation, and adequate clearance for all the wires behind
the amplifier. Once accomplished, connect the amplifier directly to
the AC mains. Do not use extension cords, as most are not suitable
for the current required by your amplifier.
3. Configure your amplifier.
The SE/select and BAL/mode buttons on the rear panel are
used when configuring your amplifier for how you would like it to
operate.
configuring channels While in standby , pressing the SE/select button will cause the SE
LED to flash three times, indicating that the amplifier is configured
for single-ended operation once the unit is taken out of
standby .
Similarly, pressing the BAL/mode button will cause the BAL
LED to flash three times, indicating that the amplifier is configured
for balanced operation once the unit is taken out of
standby .
Make sure you configure the amplifier to use the type of input
connection you will be using.