Clarke Woodworker CS4-6C, Инструкция по эксплуатации и техническому обслуживанию

Страница: 11 / 23

11
Auxiliary Mounting For Vertical Sanding
1. Remove backstop lock bolt and remove
work support.
2. Remove table assembly by removing table
lock knob and washer.
NOTE: Belt bed may be raised to vertical
position by loosening hex socket screw and
raising bed. See “Positioning Belt Bed” on page
16.
3. Attach table assembly to auxiliary holes in
belt bed. Make sure index pin is in the
upper hole when sanding table is in the
vertical position.
Squaring Table Assembly
WARNING: To avoid injury from accidental start,
make sure tool is unplugged before aligning.
1. Using a combination square, check the
angle of the worktable with the disc.
NOTE: The combination square must be “true”
- See “Assembly - Tools Needed” section on
page 8 for checking method .
2. If the table is not 90º with the disc, loosen
table lock knob screw and tilt table.
3. Adjust worktable square to the disc and
retighten table lock knob.
4. Attach scale label to 0º mark on dust guard.
Installing the Sanding Belt -Tensioning And Tracking
WARNING: To avoid injury from accidental start,
switch “OFF”, remove key and disconnect from power
outlet before removing or installing sanding belt.
On the smooth side of the sanding belt, is a “directional
arrow.” The sanding belt must run in the direction of this
arrow so that the splice does not come apart.
1. Slide tension lever to the right to release the belt
tension.
2. Place the sanding belt over the pulleys with the
directional arrow pointing as shown.
Make sure the belt is centred on both pulleys.