Clarke Vantage 17 cable, Руководство оператора, Страница: 12 / 44

ENGLISH
EN
12 Operator’s Manual - Vantage 17 Cable
While reading this Manual, the Operator must pay particular
attention to the symbols shown in the labels.
Do not cover these labels for any reason and immediately
replace them if damaged.
BEFORE MACHINE START-UP
To prepare the machine for operation, follow this procedure
before start-up.
Squeegee Installation
1. Install the squeegee (A, Fig. 5) and fix it by means of the
squeegee knobs (B), then connect the vacuum hose (C)
to the squeegee.
Solution Tank Filling
2. Fill the solution tank (A, Fig. 6) with a solution suitable for
the work to be carried out.
Do not fill the solution tank completely, leave few inches
from the edge.
Always follow the dilution instructions on the container
label on the chemical product used to create the solution.
The solution temperature must not exceed 100°F (40°C).
Brush or Pad-Holder Installation
3. Deactivate the transport/parking device (D, Fig. 5) by
putting it in position (E) after inserting the relevant pin (F).
4. Lift the brush cover (G, Fig. 5) by prying the handlebar
(H).
5. Place the brush (B, Fig. 6) or the pad-holder (C) with pad
(D) under the cover.
6. Lower the cover (G, Fig. 5) by means of the handlebar
(H).
USE
WARNING:
On some points of the machine there are some
labels indicating:
–
DANGER
– WARNING
– CAUTION
– INFORMATION
CAUTION:
Use only low-foam and non-flammable liquid
detergents, intended for automatic scrubber
applications.
NOTE:
According to the kind of cleaning to be carried out,
the machine can be equipped both with the brush (B,
Fig. 6) and the pad-holder (C) with pad (D).
7. Connect the extension (J, Fig. 5) with the power supply
cable (K). Connect the extension plug (L) to the electrical
mains.
8. Turn the brush/pad rotation switch (I, Fig. 5) to the “I”
position; then hook the brush/pad-holder by pressing for
a few seconds one or both switches (N, Fig. 5).
If the hooking operation is difficult, manually rotate the
brush/pad-holder counterclockwise (Fig. 7, next page).
Figure 5
Figure 6
WARNING:
Before connecting the machine to the electrical
mains, make sure that the frequency and voltage
shown in the serial number plate/technical data (M,
Fig. 5) match the mains voltage.
F
D
G
E
B
A
C
J
L
M K
I
H
N
B
C
D
A