Clarke Power Wash PLS190, Инструкция по эксплуатации и техническому обслуживанию

Страница: 10 / 28

10
REMOVE THE TRAVEL BUNG BEFORE USE.
1. Remove the red travel bung.
2. Inside the small bag attached is a
oil filler cap which needs to go in
its place.
BEFORE USE
IMPORTANT: The engine is supplied without any oil in it and must be filled to
the correct level before use, see below.
CHECKING THE PUMP OIL LEVEL
Look at the sight glass on the pump
to check the oil level inside the
pump.
If required, remove the oil filler cap
and top up with oil.
• We recommend the use of
SAE30 oil in this power washer.
CHECKING THE ENGINE OIL LEVEL
1. Turn the oil filler cap/dipstick anti-
clockwise and remove it from the
oil filler tube, wipe the dipstick
with a clean cloth.
2. Insert the oil filler cap/dipstick
back into the oil filler tube and
then remove it again. Do not
screw it in when doing this.
WARNING: TO CARRY OUT THIS CHECK, PLACE THE POWER WASHER ON
LEVEL GROUND WITH THE ENGINE SWITCHED OFF.
WARNING: TAKE CARE NOT TO TOUCH ANY HOT PARTS OF THE POWER
WASHER WHEN CHECKING THE OIL LEVELS.
SIGHT GLASS
DRAIN CAP
OIL FILLER CAP