13. Slide the upper tool holder up into position and secure
with self tapping screw.
Fig. 7
14. Assemble the lance to the gun with a simple bayonet connection
Fig
.8
. Attach one end of the high pressure hose to the gun
Fig. 8a
and
tighten the securing nut using a 17mm open ended spanner, DO
NOT overtighten. Connect other end of the high pressure hose
to the pump Fig .8b, hand tight only.
Fig. 8
Fig. 8a
Fig. 8b
15. Refer to the engine manufacturers handbook regarding topping up oil and fuel. Once
the oil and fuel levels are OK, the pressure washer is ready for use.
OPERATION.
NOTE: Before connecting the garden hose, unscrew and remove the hose connector which
is located on the opposite side of the pump to the high pressure hose connector
Fig.8b, check that the water filter is in place and is not damaged.
1.
Connect the garden hose to the water inlet (hand tight only).
2.
Connect the other end of the garden hose to the mains water supply and turn ON.
3.
Depress the gun trigger to clear any trapped air, keep depressed until a steady flow
of water emerges from the spray nozzle.
4.
Refer to engine handbook on starting the engine.
Move the throttle control lever to the run position.
Fig. 9
5.
Slowly press the primer ball 3 times, waiting 3 seconds
between each press. In cold weather conditions, press
the ball 5 times.
-7-
Detergent Hose
Fig. 9a
