Clarke CONTRACTOR 6462072, Инструкция по эксплуатации и техническому обслуживанию

Страница: 11 / 20

11
2. Press down on both handles to
the required depth, pushing the
bit into the work piece.
• The depth stop should be pre-
set (See “Setting The Depth Of
Cut” on page 11.)
3. Pull the plunge lock lever towards
the handle to lock the body in
position.
4. To raise the tool, push the plunge
lock lever away from the handle and allow the body to rise out of the
workpiece.
ADJUSTING THE SPEED
The tool speed can be adjusted to
suit the bit diameter and the type of
material being cut.
Generally, the larger the diameter of
the bit, the slower the tool speed
should be.
• Rotate the speed selector
wheel to adjust the speed
setting from 1 to 7.
It is advisableto make practice cuts
on a piece of scrap timber to determine the best speed.
ADJUSTMENTS
SETTING THE DEPTH OF CUT
With the appropriate bit installed, proceed as follows:
1. Fit a suitable router bit and place the tool on a flat surface.
WARNING: ENSURE THAT THE TOOL HAS REACHED OPERATING SPEED
BEFORE BEGINNING ANY CUTTING OPERATIONS.