14
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
3. Pull the cover over the frame with the help of the rope as in Diagram J,
making sure to center the cover on the frame. There should be an equal
amount overhanging at all four corners.
4. Assemble the ratchet straps (Part #29) to the web ends on the four corners
of the cover, one for each corner. Ratchet a few times to tighten the strap.
5. Insert the “S”- hook on ratchet strap into the hole on the Bent Corner Leg.
Wind the ratchet so that the webbing overlaps itself. Slide through the
fabric pockets at each leg and reattach with clamps to each leg. Repeat
this on the other side. Push down on the cover rails to tighten the cover
before tightening the bolts completely.
6. When the cover rails are all secured, proceed to the four corners and
tighten the end covers to the end frames with the ratchet action.
NOTE: Over-tightening can cause
damage to straps and/or the anchor
point.
DO NOT over-tighten)
The garage is now ready for use.
Note: Check periodically (two to
three times in the first week and
tighten ratchet tie-downs and all
hardware as needed. Monthly
inspection is recommended
throughout usage.
Содержание CIG81015
Страница 16: ......
