Clarke American Sanders 07095A, Руководство оператора

Страница: 10 / 82

EN
ENGLISH
- 10 - FORM NO. 70147B
Clarke
®
American Sanders Operator's Manual (EN) - EZ-8 Sander (CE)
945390/25
945391/25
945392/25
945930/10 945416/10
945395/25
945933/10 945418/10
945397/25
945398/25 945935/10 945420/10
945399/25 945936/10 945421/10
945400/25 945937/10 945422/10
Sanding Cuts and Sandpaper
12 grit For removing gross imperfections and restore
16 grit evenness to old fl ooring. To remove build-up of
20 grit paints and varnishes
24 grit
36 grit For the fi rst sanding of new fl ooring (maple, oak).
40 grit For removing minor imperfections and fi nishes
from old fl ooring.
50 grit For fi rst sanding of new fl ooring (cedar, pine, fi r)
For clean-up of 16 grit.
60 grit For clean-up from initial cut 36 grit.
80 grit For fi nal sanding of certain hardwoods. For
clean-up of initial cuts (50 grit).
100 grit For fi nal sanding of certain hardwoods and
conifers where a smooth surface is desired.
Grain Use
Initial Cut
The purpose of the initial cut is to remove old fi nish and gross imperfections on the fl oor surface. A coarse
abrasive should be used. If the surface is severely damaged by deep scratches, pre-existing dwell marks,
uneven planks, etc., it may be necessary to sand across or diagonally to the grain to restore evenness to the
surface. If these conditions are not present, the initial cut should be done in the direction of the grain.
If glazing, loading, or burning takes place immediately into an initial cut, select a coarser abrasive. If this
should occur during an initial cut, the abrasive has dulled and must be replaced.
Final Cuts
The purpose of a fi nishing cut is to remove the scratches produced during the initial cut. Use a fi ne (60 - 80
grit) grain abrasive.
If the surface remains rough after a fi nishing cut, it may be necessary to use an even fi ner grain of abrasive
(80 - 100 grit). Care should be taken in selecting the grit size of the abrasive. A very fi ne grain will close
the pores on a wood fl oor making admission of a stain dif fi cult.
If glazing or burning should occur immediately into a fi nishing cut, increase pace. If it should occur during a
fi nishing cut, the abrasive has dulled and must be replaced.
8 x 18
19
/
32
Sheet 8x 19 Sleeve 8 x 18
55
/
64
Sleeve
Part No./ Cnt. Cloth Back Paper Back
Part No./Cnt. Part No./Cnt.