M0061_D
Page 1 of 2
Installation Instructions for 610-1046
TEE Storage Tube & Holder
The storage tube is designed to safely store a single TEE probe in a vertical position after it has
been disinfected and rinsed.
1.
Choose desired location for the storage tube.
2.
Place the storage tube against the wall with the storage tube bottom above the floor
(see sketch). Mark the wall at the top of the storage tube. Place the Upper Bracket
(with the two ‘ears’ pointing up) at this mark ensuring it is parallel to the floor. Mark
with a pencil through the screw holes on wall and remove bracket.
3.
For a sheetrock wall, screw the E-Z anchors (supplied) directly into the wall and
install mounting screws. For masonry walls use suitable anchors (not supplied). For
wood walls use the screws only.
4.
Install Upper Bracket and tighten screws.
5.
Place storage tube in Upper Bracket.
6.
Slide Lower Bracket over bottom of tube and raise it up about six inches from
bottom of tube.
7.
Ensure that the tube is vertical and mark the holes through the Lower Bracket on
wall. Install E-Z Anchors and screw Lower Bracket into wall.
8.
To place tube in brackets, slide it into the Lower Bracket first then over the ‘ears’ of
the Upper Bracket. The open slot of the tube should be facing you.
9.
Locate connector holder and strain relief on wall and install as above.
The slot on the front of the tube allows you to ‘feed’ the probe into the tube without having to
stress the probe. The handle of the probe ends up resting securely in the top of the tube.
If you have any questions or concerns, please call CIVCO Medical Solutions at:
1-800-445-6741
102 First Street South
•
Kalona, IA 52247
•
Tel: (800) 445-6741
•
Fax: (877) 329-2482
•
WWW.CIVCO.COM
