Citrix ByteMobile T1010, Установка, настройка и администрирование

Страница: 69 / 172

T-Series Traffic Director Installation, Configuration and Administration Guide 2-29
Accessing and Configuring the Management Plane
Accessing and Configuring the Management Plane
After you have installed the T1000 in a rack and applied power, you are ready to perform the
initial configuration of the management plane.
To perform the initial configuration, you can use the LCD keypad or the setup wizard. You
can access the setup wizard from any computer that is on the same network as the new
T1000. However, because this method uses the T1000 default IP address, you must install
and configure one T1000 at a time. If you want to configure a new T1000 from a remote
network, or if you want to install multiple T1000s and then configure them without using
the console port, you can use Dynamic Host Configuration Protocol (DHCP) to assign each
new T1000 an IP address at which you can access the T1000 for remote configuration.
After you complete the initial management plane configuration, you can configure secure
access to your T1000. As a result, you are no longer prompted for a password when logging
on. This is especially helpful in environments for which you would otherwise have to keep
track of a large number of passwords.
Using the LCD Keypad
When you first install the T1000, you can configure the initial settings by using the LCD
keypad and display module on the front panel.
The configuration file (ns.conf) should contain the following command and default values.
set ns config -IPAddress 192.168.100.1 -netmask 255.255.0.0
The LCD keypad has the following functions:
Caution:
Statement 5:
The power control button on the device and the power switch on the power supply do
not turn off the electrical current supplied to the device. The device also might have
more than one power cord. To remove all electrical current from the device, ensure
that all power cords are disconnected from the power source.
DC Power Option:
OFF