CITIZEN QUARTZ
NIGHT ROLLERS II
Model No. MC5XXX
Cal. No. D298
• Instruction Manual
CTZ-B6907
Thank you for purchasing a CITIZEN QUARTZ
Watch. To ensure correct use, please read these
instructions carefully. Please confirm that the
CITIZEN International Guarantee Card is included
for your possible claim.
1. SWITCHING FUNCTION DISPLAYS
• This watch is equipped with six functions
consisting of time and calendar, alarms 1 and 2,
stopwatch, timer, dual time and chime (hour time).
2. SETTING THE TIME AND CALENDAR
1. Pressing and holding button
B
in for at least 2
seconds digit to flash enabling the seconds to be
set.
2. Press button
A
to reset the seconds.
• When the seconds displayed are from 30 seconds
to 59 seconds, pressing the button
A
returns
the seconds digits to zero and advances the
minutes by 1.
3. Each time button
B
is pressed, the flashing
portion of the display will change as shown
below. Press button
B
until the digit of the
display you want to correct flashes.
4. Press button
A
to set the flashing digit of the
display.
• Pressing and holding button
A
in will cause
the flashing digit to advance rapidly.
✩
Pressing button
M
in any of the setting states
returns the watch to the time and calendar display.
✩
If a button is not pressed for 1 minute in any of
the setting states, the watch will automatically
return to the time and calendar display.
3. USE OF ALARMS 1 AND 2
• The procedure for setting the alarm for alarm 1
and alarm 2 is exactly the same. Only the beeping
tone is different.
1. Press button
M
to select alarm 1 or
alarm 2. The alarm mark will flash.
2. Press and hold button
B
in until
the “hour” digit flashes. The “hours”
can be set by pressing button
A
(holding button
A
in will cause the
display to advance rapidly).
3. When button
B
is pressed, the flashing digit will
change from “hours” to “minutes”. Set the
“minutes” with
A
.
4. Pressing button
B
returns the watch to the
normal alarm state.
✩
The alarm sounds for 20 seconds.
✩
Pressing any of the buttons will turn the alarm
sound off.
✩
When desiring that the alarm not sound at the
set time, press button
A
while in alarm mode to
switch from the “alarm time display” to the “OFF
display”.
✩
When switching from the alarm OFF display to
the alarm ON display (alarm time display),
holding button
A
in enables you to listen to the
alarm sound.
When reading this instruction manual please
keep the watch diagram above in view. Symbols
(
A
.
B
, etc) used in the sections on operating
instructions refer to the symbols indicated in
this diagram.
