H41*
Abbreviated instruction
• This watch is solar-powered. Expose the dial to light and use it sufficiently charged.
• To see details of charging time, specifications and operations, refer to the instruction manual.
English
Reception-in-progress
indication (RX)
Reception result
indication (NO)
Reception result
indication (H/M/L)
Button
B
Date indication
Crown
Button
A
Minute hand
Hour hand
Second hand
• Actual appearance may differ from the illustration.
• The crown has two positions when pulling it out.
Checking the signal reception result
• This watch receives the time signal from the Japan station every day to adjust
time automatically.
1.
Push the crown in to position
0
.
2.
Press and release the lower right button
A
.
The second hand moves to indicate the result of the last reception.
Indication
Reception result
H
The reception was successful in a very good condition.
M
The reception was successful in a good condition.
L
The reception was successful in a not-good condition.
NO
The reception failed.
• Try signal reception following the steps in
if the last reception failed.
3.
Press and release the lower right button
A
to finish the
procedure.
The indication returns to current time.
• It returns to current time indication automatically in about 10 seconds
without pressing the button.
Receiving the signal manually (on-demand reception)
• It takes 2-15 minutes to finish reception.
1.
Push the crown in to position
0
.
2.
Press and hold the lower right button
A
for 2 seconds or more.
The second hand points “RX” and signal reception starts. The second hand
returns to normal movement after finishing reception.
Reception was successful
The time will be updated.
Reception failed
The time is not corrected and the previously set time
resumes.
• Press and hold button
A
for 2 seconds or more to cancel reception.
Component identification
Crown's position
0 1 2
Adjusting the time and calendar manually
Setting the time and date
1.
Pull the crown out to position
2
.
The second hand points 0 second.
2.
Rotate the crown to adjust time and date.
• When you rotate the crown quickly a few times, the hand will move
continuously. To stop the rapid movement, rotate the crown in either
direction.
• The hour and minute hands move synchronously.
• Change of date indication shows it just became AM. Take care the time set
is AM or PM.
• To adjust the hour and date faster, see
.
3.
Push the crown in to position
0
in accordance with a reliable
time source to finish the procedure.
Setting the year and month
1.
Pull the crown out to position
1
.
The second hand indicates year and month currently set.
2.
Rotate the crown to adjust year and month.
• Year and month are indicated with the second hand.
12
1
2
3
4
5
6
7
8
9
10
11
“Month” corresponds to one of
the 12 zones shown in the figure
below.
Each number means month.
“Year” corresponds to the years
since leap year and is indicated
with markers in the zone of each
month.
Years since leap year:
0
(Leap
year)
0
Years since leap year:
1
1
Years since leap year:
2
2
3
Years since leap year:
3
3.
Push the crown in to position
0
to finish the procedure.
