Citizen CT-D150, Справочник по командам

Страница: 102 / 512

Support
model
CT-S280 CT-S300 CT-S2000 CT-S4000 CT-S251 CT-D150/E351
CT-S281 CT-S310 CT-S801/851 CT-S601/651 CT-P29x series CT-S310II
CT-D151/E651
- 101 -
ESC a n
[Function] Aligning the characters
[Code] <1B>H<61>H<n>
[Range] 0
≤n≤2, 48≤n≤50
[Outline] [The specification which is common to the model]
• All the printed data within one line are aligned in the specified position.
• Depending on the value “n”, positional alignment is carried out as shown in the table below:
n Position
0, 48
Left end alignment
1, 49
Centering
2, 50
Right end alignment
[Caution] [The specification which is common to the model]
• This command is valid only when it is inputted at the beginning of a line.
• This command does not affect the PAGE MODE.
• Executes justification in the print area being set.
[Default] n=0
[Sample Program]
LPRINT CHR$(&H1B);"a"; CHR$(0);
LPRINT "AAAAA"; CHR$(&HA);
LPRINT CHR$(&H1B);"a"; CHR$(1);
LPRINT "AAAAA"; CHR$(&HA);
LPRINT CHR$(&H1B);"a"; CHR$(2);
LPRINT "AAAAA"; CHR$(&HA);
[Print Results]
AAAAA
AAAAA
AAAAA
Paper feed direction
Left-justified Centered Right-justified