Citizen C080 Скачать руководство пользователя страница 14

Marking

Marking

Water-resistant

on the Dial

on the 

characteristics

Caseback

Face washing,

Swimming

Skin diving

Scuba diving

splashes,

(diving

(diving with

sweat,

without air 

tanks)

raindrops, etc.

air tanks)

Non water-resistant 

NONE

NONE

NO

NO

NO

NO

watch and must be kept
away from water.

An ordinary water-resistant

NONE

WATER

OK

NO

NO

NO

watch and can withstand

RESIST

splashes, sweat, rain-drops
and etc. for daily life use.

WR100M

WATER

For frequent use with 

WR10bar

RESIST

OK

OK

OK

NO

water. It is not specially 

WR150M

designed for scuba diving.

For skin and scuba diving.

WR200M

WATER

OK

OK

OK

OK

Usable up to the respective

RESIST

indicated depths.

TEMPERATURE CARE

Avoid temperature extremes. Exposing your watch to high
temperatures, such as placing it on the dashboard of a vehicle
or use in a hot tub, may cause the watch to malfunction,
shorten battery life or damage certain components. Leaving
the watch in extreme cold temperatures may cause irregular
timekeeping until the watch returns to normal operating
temperature.

SHOCK-RESISTANT

The watch may be worn while playing golf or other activities,
but avoid severe shocks such as dropping it on a hard surface. 

MAGNETIC-RESISTANT

No problem should occur from using the watch around
ordinary household electric appliances such as TV sets or
stereos.  Keep away from magnets.

CHEMICAL/GAS RESISTANT

Do not expose the watch to chemicals or gases for long
periods.

WATCH CLEANING

Stains, waterspots and accumulated dirt on the case, crystal
or band should be removed with a soft cloth to prevent
damage and premature wear.

HANDLING OF WATER-RESISTANT WATCHES

Although water-resistant watches are warranted, steps should
be taken to avoid damage that may result from
accidents or mishandling:

Do not operate the crown or push-button in the water or

while the watch is wet. Tighten screw lock crown completely.

Should the watch become immersed in water, dry it off

right away. If the watch comes in contact with salt water, be
sure to rinse it thoroughly in warm fresh water to remove any
trace of salt.

I

f a watch is wet from cleaning or by accident, never store it

in a closed container. It should be dried immediately or taken
to a watchmaker or jeweler if moisture is inside the case to
prevent damage from rust.

Vital components necessary to resist the entrance of

moisture deteriorate with time and use. Gaskets, crowns and
other materials should be replaced every year or two to ensure

PRECAUTIONS ABOUT CARE AND
HANDLING OF WATCHES

that water resistant quality remains at factory specifications.

CARE FOR METAL BRACELETS

To extend the life and maintain the good appearance of the
metal watch bracelet, the following recommendations are
given:

Be aware that since the watch and bracelet is worn next to

the skin, it collects dust and perspiration and becomes soiled if
not cleaned regularly. This is particularly true of the inner parts
of the links or mesh of the bracelet.

Soil and rust, when present in a bracelet, are dissolved by

perspiration and can cause staining of cuffs and
irritation of the skin in some instances.

Heavy perspiration should be wiped off the watch and

bracelet with a soft dry cloth. The bracelet should be cleaned
occasionally by using an old toothbrush and warm soapy
water after which the soap is thoroughly rinsed with clear water
and the bracelet dried completely. The foregoing manner of
cleaning should not be done if the watch is not water-resistant
but  should instead be done by your jeweler.

CARE FOR STRAPS

LEATHER

Heavy perspiration, if not removed from a leather strap, can

wash out the natural oils and cause the leather to become dry
and deteriorate. Any moisture should be blotted with a soft dry
cloth or paper towel and the strap allowed to dry naturally.

Salt residue and soil can be removed from the leather by

cleaning with a dampened soft cloth and mild soap or saddle
soap.

Occasionally, the inside surface of the strap should be

cleaned by using a soft cloth dampened with alcohol.

The strap should always be worn a little loosely (one finger

space between wrist and strap) to allow air to circulate thus
causing any moisture to evaporate.

RUBBER

Rubber straps should be washed frequently with mild soap

and warm water using a soft brush.

Thorough cleaning, using the same method, should

especially be done after use in salt water.

Solvents, oils, perspiration, tanning lotion and salt can cause

rubber to deteriorate if not removed.

Return to Table of Contents

Return to Table of Contents

Содержание C080
















Отзывы: