8989
Abbreviated instruction
• To see details of specifications and operations, refer to the instruction manual.
English
Component identification
Button
B
Mode
Indication
Analog
indication 1
Button
M
Button
C
Analog
indication 2
Temperature
sensor
Button
A
Digital
indication
• Actual appearance may differ from the illustration.
Using the light
1.
Press the lower left button
C
.
The light turns on.
Changing indication of the analog indication 2
1.
Press and release the upper left button
M
repeatedly to change
the mode to any one other than [CHR].
2.
Press and release the upper right button
B
repeatedly to
change the indication.
“
▲
” on the digital indication shows the current indication of the
analog indication 2.
▲
Indication
SEC
The “second” of the time of the mode [TIME]
ALARM The “hour” of the alarm time set
DU. T
The “hour” of the dual time
Setting the time
1.
Press and release the upper left button
M
repeatedly to change
the mode to [TIME].
2.
Press and hold the upper right button
B
for 2
seconds or more.
The “second” on the digital indication starts blinking and
becomes adjustable.
3.
Press the lower right button
A
in accordance with a reliable
time source.
4.
Press and release the upper right button
B
repeatedly to
change the target to be set.
• Each time you press the button, the target changes as follows:
Second
Minute
Hour
12/24 hour basis
Analog indication 1
Analog indication 2
5.
Press and release the lower right button
A
to adjust the target.
• Pressing and holding the button changes indication continuously when
adjusting “hour” and “minute”.
• “A” or “P” is displayed to indicate AM or PM in 12-hour basis indication.
• When setting the analog indication 1, set it to the same time as that of
the digital indication. Pressing and holding the button changes indication
continuously.
• When setting the analog indication 2, set its hand to the 12 o’clock position.
Pressing and holding the button changes indication continuously. Pressing
button
B
after setting the analog indication 2 finishes time setting.
6.
Repeat steps 4 and 5 to set other targets.
7.
Press and release the upper left button
M
to finish the
procedure.
