Cisco WAP571, Руководство администратора

Страница: 146 / 192

SNMP
General SNMP Settings
Cisco WAP571/E Administration Guide 146
10
General SNMP Settings
You can use the General page to enable SNMP and configure basic protocol
settings.
To configure general SNMP settings:
STEP 1
Select SNMP > General in the navigation pane.
STEP 2
Select Enabled for the SNMP setting. SNMP is disabled by default.
STEP 3
Specify a UDP Port for SNMP traffic.
By default, an SNMP agent listens only to requests from port 161. However, you
can configure this so that the agent listens to requests on a different port. The valid
range is from 1025 to 65535.
STEP 4
Configure the SNMPv2 settings:
• Read-only Community —A read-only community name for SNMPv2
access. The valid range is 1 to 256 alphanumeric and special characters.
The community name acts as a simple authentication feature to restrict the
machines on the network that can request data to the SNMP agent. The
name functions as a password, and the request is assumed to be authentic
if the sender knows the password.
• Read-write Community —A read-write community name to be used for
SNMP set requests. The valid range is from 1 to 256 alphanumeric and
special characters.
Setting a community name is similar to setting a password. Only requests
from the machines that identify themselves with this community name are
accepted.
• Management Station —Determines which stations can access the WAP
device through SNMP. Select one of these options:
- All —The set of stations that can access the WAP device through SNMP
is not restricted.
- User Defined —The set of permitted SNMP requests is restricted to
those specified.