Cisco WAP571, Руководство администратора

Страница: 10 / 192

Getting Started
Using the Access Point Setup Wizard
Cisco WAP571/E Administration Guide 10
1
then select Add . Add the intranet address of the Access Point (http:// <ip-
address> ) to the local intranet zone. The IP address can also be specified
as the subnet IP address, so that all addresses in the subnet are added to
the local intranet zone.
• If you have multiple IPv6 interfaces on your management station, use the
IPv6 global address instead of the IPv6 local address to access the Access
Point from your browser.
Logging Out
By default, the web-based AP configuration utility logs out after 10 minutes of
inactivity. See
HTTP/HTTPS Service for instructions on changing the default
timeout period.
To log out, click Logout in the top right corner of the web-based AP configuration
utility.
Using the Access Point Setup Wizard
The first time that you log into the Access Point (or after it has been reset to the
factory default settings), the Access Point Setup Wizard appears to help you
perform initial configurations. Follow these steps to complete the wizard:
You must log in again after changing your password.
STEP 1
Click Next on the Welcome page of the Wizard. The Configure Device - IP
Address window appears.
STEP 2
Click Dynamic IP Address (DHCP) if you want the WAP device to receive an IP
address from a DHCP server. You can also select Static IP Address to configure
the IP Address manually. For a description of these fields, see IPv4 Setting .
STEP 3
Click Next . The Single Point Setup-Set a Cluster window appears. For a
description of Single Point Setup, see Single Point Setup Overview .
STEP 4
To create a new Single Point Setup of WAP devices, select Create a New Cluster
and specify a New Cluster Name . When you configure your devices with the
same cluster name and enable Single Point Setup mode on other WAP devices,
they automatically join the group.